The W&H Molder's low cost and its capacity to produce high quality moldings is an unbeatable combination.
The machine takes little room in your shop and gives you control of your lead times, costs, and quality.
The W&H Molder provides a safer alternative to a shaper and makes the entire profile in one pass. Some deep and wide profiles require prior relief cuts.
The machine uses a two-knife system. Knife placement is preset. No time is lost in setting knives with a gauge.

Specifications
• 2 hp motor
• 7000 rpm arbor
• 15 fpm feed rate
• max profile depth 3A"
• max profile width Q%"
• planes 7" wide
• min stock length 9"
• min stock thickness W
• max stock thickness 8"
All molding cuts must be at full depth and made in a single pass.
• working height 31"
• overall height 45"
• overall width 20"
• overall length 33"
• pkg. wt. approx. 220#

Warranty
7-year limited warranty against defects in materials and workmanship, non-transferable.
The motor is covered under its own 1 -year warranty.